get an error if i press calculate-1 button without entries in the 4 Labels in Red

How do i change code in the userform so that i must have entries in the following Textboxs which are Red in colour on the Userform....i get an error if i hit the Calculate-1 button without entries in these 4 textbox`s
System Feed Flow
Feed Concentration
Outlet Concentration
CT Feed Flow

Also how do i make the results show as whole numbers?

Also can the colour of the numbers in the result box`s be Blue?

Still new to VBA code so i have i made this coding correct...it does work though

Best Regards

Jeff

Hi Jeff still new to VBA myself but I think this should work at the end of your command button code

If UserForm1.TextBox7.Value = "" Then
MsgBox "Please enter a System Flow Rate"
Exit sub
End If

also use this example to change the font colour

Me.TextBox7.ForeColor = vbBlue

hope this helps

Put following code at start of commandbutton-code

Code:

---

    For Each it In Array(7, 8, 9, 17)
        If Me("Textbox" & it) = vbNullString Then MsgBox "Missing value": Exit Sub
    Next

---

Coloring textboxtext will only work if enabled. They are now greyed out because of disabling them.

Thanks for help

When all entries are in the userform i then want this transferred to Result Sheet...the code i used gives error...where have i gone wrong please

When i transfer the 1st data to column D , the next entries into column E through to column I

Jeff

I made a couple of changes but still get error

I tried by changing Rows to column in code but still error

Regards

Jeff

Code:

---

Private Sub CommandButton5_Click()
   
    With Sheets("RESULTS")
        myarray = Array(TextBox7.Value, TextBox8.Value, TextBox9.Value, , TextBox4.Text, TextBox5.Text, , _
            TextBox6.Text, TextBox1.Text, , TextBox2.Text, TextBox3.Text, , TextBox10.Text, TextBox11.Text, , _
            TextBox12.Text, TextBox13.Text, TextBox14.Text, TextBox15.Text, TextBox16.Text, , _
            TextBox17.Value, TextBox18.Text, TextBox19.Text, TextBox20.Text, TextBox21.Text)
        mycol = .Cells(6, .Columns.Count).End(xlToLeft).Offset(, 1).Column
        For i = 0 To UBound(myarray)
            .Cells(i + 6, mycol) = myarray(i)
        Next
    End With
   
  MsgBox "Data Transferred"
 
End Sub

---

Thank you
I keep getting a zero number for Textbox5....tried changing the formula but always get a zero?
In the userform i get some numbers with a decimal point...can all answers be a whole number?

Cheers

Check the order of Textbox-calculation in your Calculate-code.
Check F1 for rounding numbers( Round, Roundup, Rounddown)

I must be missing something here as i have tried many combinations to get a value in Solids in Concentration (userform Textbox5)....the values are visible in all textboxs on Userform except for the value in Textbox5
Jeff

jeff,

To calculate TB5 you need the value of TB1 too, but TB1 is still empty at that time because you only calculate it's value two steps further in your code.